NEO Spare Base Module Instructions
10400858-001
©2018 Overland Storage, Inc.
Page 5 of 7
Move Controller
1.
At the
old
Base Module, loosen the
two blue captive
thumbscrews
on the controller and slowly remove it from
the Base Module, setting it aside.
2.
If a
drive power board
is installed, also move it:
a.
Push down the drive power board
latch
to release it.
b.
Slowly slide the
drive power board
out of the module.
c.
At the new Base Module, position the drive power
board onto the
alignment rails
.
d.
Slide the
drive power board
in until seated firmly.
e.
Push the board
latch
up until it snaps into place.
3.
At the
new
Base Module, position the
controller
on the
alignment rails and slide it in until it is flush with the
back panel of the module
.
4.
Tighten the
thumbscrews
with your fingers to secure it
to the module
.
Install New Base Module
Insert the Module in Rack
WARNING:
To avoid injury, it is recommended that a
mechanical lifter (or at least two people) be used for rack
installation or removal.
WARNUNG:
Um Verletzungen zu vermeiden, empfehlen wir zur
Rack-Installation oder -Deinstallation die Nutzung einer
mechanischen Hebehilfe (oder mindestens zwei Personen).
AVERTISSEMENT:
Afin d’éviter des blessures pendant
l’installation, il est recommande d’utiliser un monte-charge (ou
au moins deux personnes) pour élever ou aligner l’module.
1.
Using the mechanical lifter, position the
module
in front,
aligned with the rack rails.
2.
Slide the module onto the
rail flanges
and into the rack.
3.
Tighten the
recessed screws
only one turn to hold it.
Aligning and Connecting the Module
Aligning the Base Module with the library ensures that the
robot can move freely between the modules.
NOTE: The library will not operate unless the alignment
mechanism is in the locked position (except the bottom module).
1.
At the back of the library, using the
alignment lock
lever
, align and lock the new Base Module to the modules
to which it connects.
If you encounter resistance, adjust the upper module so
that the alignment mechanism pin moves into the mating
hole in the lower module.
2.
Verify that, for the
lowest
module in the library, its
alignment mechanism is in the
unlocked position
.
3.
From the front of the library, tighten the
Phillips screws
on both the Base Module and the adjacent modules to
secure them all to the rack.
Recessed Screws
Alignment Locks
