NEO Spare Base Module Instructions
10400858-001
©2018 Overland Storage, Inc.
Page 3 of 7
Remove Tape Drives
NOTE: Because the library tracks the drive locations and issues
events if the drives aren't in the expected locations, label the drives
so they can be reinstalled in the same drive bays.
1.
Use your fingers to loosen the
blue thumbscrews
on the
tape drive.
2.
While supporting the bottom of the drive, pull straight
back on the tape
drive handle
to remove it from the
module.
CAUTION:
Support the bottom of the tape drive when
removing it to avoid damaging any internal connections.
3.
Place the drive on a secure
ESD surface
.
4.
Repeat
for any
additional drives
.
Remove Base Module from the Rack
WARNING:
To avoid injury, it is recommended that a
mechanical lifter (or at least two people) be used for rack
installation or removal. Use care during rack installation or
removal to avoid accidentally tilting or tipping the rack,
causing damage or personal injury.
WARNUNG:
Um Verletzungen zu vermeiden, empfehlen wir zur
Rack-Installation oder -Deinstallation die Nutzung einer
mechanischen Hebehilfe (oder mindestens zwei Personen).
Seien Sie vorsichtig bei der Rack-Installation oder -Entnahme,
um ein versehentliches Kippen des Racks zu vermeiden und
das Rack nicht zu beschädigen bzw. sich selbst zu verletzen.
AVERTISSEMENT:
Afin d’éviter des blessures pendant
l’installation, il est recommande d’utiliser un monte-charge (ou
au moins deux personnes) pour élever ou aligner l’module.
Faites attention lorsque vous insérez ou retirez l’module d’un
support, pour empêcher le déversement accidentel de la
crémaillère causant des dommages et des blessures.
1.
If there is
module
immediately above and/or below it:
•
From the front of the library, use a screwdriver Phillips
#2 to loosen the screws two full turns on the Base
Module and the adjacent modules.
•
From the back of the library, unlock the alignment
mechanisms connecting the Base Module with all
adjacent modules.
2.
Position the
mechanical lifter
in front of and even with
the Base Module.
3.
Slide the Base Module out of the rack onto the lifter.
4.
Place the module on a secure
ESD surface
.
5.
Unpack the
new
Base Module and place in on the surface
next to the old module.
6.
Remove the
tape magazines
from the new unit using the
Recessed Screws
Alignment Release
