NEO Spare Base Module Instructions
10400858-001
©2018 Overland Storage, Inc.
Page 4 of 7
Swap Components
Move Covers
IMPORTANT: When replacing an Base Module in either the top
or bottom position, you must move the cover from the old Base
Module to the new one.
To move a
top
cover:
1.
At the old Base Module, unlock the top cover by pushing
two small screwdrivers
down and inward in both slots.
2.
Lift the top cover
front edge
by about 4.75 in. (12cm) and
pull the cover gently forward to disengage from the pivot
point at the module center.
3.
At the new Base Module, with the cover at the same angle,
reengage the
rear of the cover
at the pivot point.
4.
Lower the front of the top cover until the
latches
engage
on both sides.
To move a
bottom
cover:
1.
Place both Base Modules
upside-down
.
2.
At the old Base Module, insert a small flathead or Torx
screwdriver
into the release hole and slide it about 1/4
in. (4mm) sidewards to unlock the spring loaded lock.
3.
Raise the
cover front end
by about 4 in. (10cm) and
gently pull it forward to disengage from the pivot point at
module center and remove.
4.
At the new Base Module, with the cover at the same angle,
reengage the
rear of the cover
at the pivot point.
5.
Lower the front of the cover until the
latch
engages.
Move Power Supplies
1.
At the
new
Base Module, remove the appropriate power
supply
covers
.
2.
At the
old
Base Module, loosen the
two blue captive
thumbscrews
with your fingers on the power supply.
3.
While supporting the bottom, pull the
power supply
straight back to remove it from the module.
4.
At the
new
Base Module, position the power supply onto
the
alignment rails
.
5.
Slide the power supply into the
module
until it is flush
with the back panel of the module
.
6.
Tighten the
thumbscrews
with your fingers to secure it.
7.
If necessary, repeat these steps for a
redundant power
supply
.
8.
Install the removed power supply
covers
on the
old
Base
Module.
