3
A. FLAG ANGLES (AS REQUIRED):
A1. Fully Adjustable (F.A.) Flag Angles
A2. Wall Clips (As Required)
A3. Flag Angles (As Required)
B. JAMB BRACKETS (AS REQUIRED):
B1. Fully Adjustable (F.A.) Jamb Brackets
C. TRACK ROLLERS (AS REQUIRED):
C1. Short Stem Track Rollers
C2. Long Stem Track Rollers
D. GRADUATED END HINGES:
D1. Single Graduated End Hinges (S.E.H.), Industry Standard
D2. Double Graduated End Hinges (D.E.H.), Industry Standard
E. STACKED SECTIONS:
E1. Top Section
E2. Intermediate(s) Section
E3. Lock Section
E4. Bottom Section
F. TOP FIXTURES (AS REQUIRED):
F1. Top Fixture Assemblies (As Required)
F2. Top Fixture Slides - (A-Shaped)
F3. Top Fixture Bases - (A-Shaped)
F4. Top Fixtures
G. STRUT(S) (AS REQUIRED):
G1. Struts (U-shaped)
H. TRACKS (AS REQUIRED):
H1. Left Hand and Right Hand Horizontal Track Assemblies
(For Standard Lift Applications)
H2. Left Hand and Right Hand Horizontal Track Assemblies
(For Low Headroom Applications)
H3. Left Hand and Right Hand Vertical Tracks (As Required)
H4. Left Hand and Right Hand Riveted Vertical Track Assemblies (As Required)
I. TORSION SPRING ASSEMBLY (AS REQUIRED):
I1. Center Bracket (As Required)
I2. Torsion Shaft
I3. Left Hand and Right Hand End Bearing Brackets (As Required)
I4. Left Hand and Right Hand Cable Drums
I5. Right Hand and Left Hand Torsion Springs (As Required)
I6. Center Bracket Bearing (As Required)
I7. Counterbalance Lift Cables
J. REAR BACK HANGS:
J1. Left Hand Rear Back Hangs Assemblies
J2. Right Hand Rear Back Hangs Assemblies
K. BOTTOM CORNER BRACKETS (AS REQUIRED):
K1. Left Hand And Right Hand Bottom Corner Brackets
A1.
A1.
B1.
B1.
C1.
C2.
C1.
C1.
D2.
E4.
E1.
E2.
E3.
F2.
F1.
F2.
F1.
G1.
H1.
H2.
H3.
J2.
J1.
D1.
NOTE:
The illustrations shown on this page are general
representations of the door parts. Each specific door
models may have unique variations.
K1.
F3.
I5.
I7.
I5.
I3.
I3.
I6.
I4.
H4.
H4.
K1.
I1.
I2.
H3.
I4.
I7.
I6.
F4.
F4.
A2.
A2.
A3.
H2.
H1.
F3.
BREAKDOWN OF PARTS
