Over Armour Offroad KAW-TERYX-FC01, Инструкции по установке и уходу

Страница: 2 / 7

Fig. B
5. Thenext step is to apply the two 12” adhesive Velcro strips onto both sides of the roll
cage.
Clean the area with rubbing alcohol and apply three inches below the seat belt
mount as shown in fig. C. Apply the two 15” adhesive strips to the upper tubes on both
sides as shown in fig. D. See also fig. H at the end of these instructions.
Fig. D
Fig. C
6. After attaching Velcro, loosely drape the cab enclosure over the roll cage. Pull down on
the back and front then lift the top and pull the 15” Velcro tab over and attach to the
adhesive strip in fig. D. While pulling down on the backside of the door pull the 12”
Velcro tab around and attach to the adhesive strip in fig. C. You may have to adjust the
tabs so that the rear panel is centered or the door zippers may be difficult to close.
7. Next reach in and pull the bottom of the rear panel down to attach to the two 10”
adhesive strips pictured in fig. B. You may now reinstall the seats.