Installation & initial operation
"R-Tronic" + "R-Con"
32
The
newly installed module C is not yet ready to operate
after connection
of the wireless receiver to the 230 V network (see paragraph 4.5.6). It first has
to be detected by the wireless receiver.
1.
Starting from its normal position (radio symbol), turn the
rotary switch of
the wireless module
counter clockwise to
"Config"
(LED flashes constantly).
2. Turn the
lower rotary switch of the new control module "T 2P" (C)
clockwise until stop. Detection of the new module is indicated by a short
green flashing
of the LED of the wireless module.
If further modules have been added to the wireless receiver before, step
2 has to be repeated at each new module.
Finally, turn the lower rotary switch back to
RUN
.
3. Set the
switch of the wireless module
back to its normal position
(
radio symbol/RUN
) by turning it clockwise.
X
The new control module was put into operation successfully.
(illustration 21)
C
NOTE
The rotary switch of the wireless
modules has to be set back to its
normal position after each reconfigu-
ration (step 3).
The wireless receiver is only ready to
operate if the rotary switch is set to
the radio symbol.