E-25-7-E
3
CONVENTIONS
Shown in this manual are the signal words NOTE, CAUTION and WARNING, as described in the
examples below:
NOTE: Notes are separated from the general text to bring the user’s attention to important
information.
CAUTION: Caution statements signal the user about hazards or unsafe practices which could
result in minor personal injury or product or property damages.
WARNING: Warning statements signal the user about hazards or unsafe practices which
could result in severe personal injury or death.
9. SETTING UP OR CHANGING PARAMETERS ........................................ 20
9.1 How to Change Parameters (batch setup and other setup modes)
............. 20
9.. Batch Setup Mode .............................................................................. 20
9.1.1.1 Operation (batch setup mode)
............................................ 20
9...2 Example of Batch Setup ..................................................... 2
9..2 Setup Mode ........................................................................................ 22
9.1.2.1 Operation (setup mode)
...................................................... 23
9.2 Construction of Internal Assembly ................................................................ 24
9.3 Removal of Internal Assembly ...................................................................... 24
9.4 Assembling the Internal Assembly ................................................................ 25
9.4. Installing the Power Supply Board and Output Board ........................ 25
9.4.2 Installing the Front Panel .................................................................... 25
9.5 Setup or Change on the Power Supply Board.............................................. 26
9.5. A change in the Power to Pulse Generator ........................................ 26
9.5.2 Configuring the Flow Signal Input Circuit for the Companion
Pulse Generator ................................................................................. 26
9.5.3 Input Frequency Division (hardware) Selection
.................................. 26
9.6 Setup on the Output Board ........................................................................... 27
9.6. Buzzer Sound Setup on Alarm (missing pulse, overmeasurement,
and parameter error) Detection
.......................................................... 27
9.7 Reconfiguration on the Display Board
.......................................................... 27
9.7. Total Counter Output Pulse Width Selection ...................................... 27
10. TROUBLESHOOTING .............................................................................. 28
0. Inspection Items ......................................................................................... 28
0.2 Inspection of Fuse ...................................................................................... 29
0.3 Dielectric Test Voltage ................................................................................ 29
0.4 Q&A Controller Behavior in Standby Mode ................................................ 29
11. GENERAL SPECIFICATIONS .................................................................. 30
12. PRODUCT CODE EXPLANATION ........................................................... 31
