13
12
INSTRUCTION
INSTRUCTION
9 Troubleshooting
7 Cleaning and maintenance
WARNING!
Always disconnect the device from the mains before you clean and service it.
NOTICE! Risk of damage
• Never clean the cooler under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning as these can damage the cooler.
• Occasionally clean the device interior and exterior with a damp cloth.
8 Guarantee
The statutory warranty period applies. If the product is defective, please contact the manufacturer’s branch in
your country (see the back of the instruction manual for the addresses) or your retailer.
For repair and guarantee processing, please include the following documents when you send in the device:
• A copy of the receipt with purchasing date
• A reason for claim or description of the fault.
Fault
Possible cause
Suggested remedy
Device does not function, LED
does not glow
There is no voltage present in the
12/24 V socket (cigarette lighter)
in your vehicle.
The ignition must be switched on
in most vehicles to apply current
to the cigarette lighter.
No voltage present in the AC
voltage socket.
Try using another plug socket.
The device fuse is defective
Replace the device fuse, see
“Replacing the device fuse” on
page 17
The integrated mains adapter is
defective
This can only be repaired by an
authorized repair centre.
The device does not cool (plug is
inserted “POWER” LED is lit).
Defective compressor
This can only be repaired by an
authorizedcustomer services unit.
The device does not cool (plug
is inserted, “POWER” LED flashed
orange, display is switched off ).
Battery voltage is too low.
Test the battery and charge it as
needed.
When operating from the 12/24-V
socket (cigarette lighter): The
ignition is on and the device is
not working and the LED is not
lit. Pull the plug out of the socket
and make the following checks
The cigarette lighter socket
is dirty. This results in a poor
electrical contact
If the plug of your cooler
becomes very warm in the
cigarette lighter socket, either the
lighter socket must be cleaned or
the plug has not been assembled
correctly
The fuse of the 12/24 V plug has
blown.
Replace the fuse(10A) in the
12/24 V plug, see “ Replacing the
plug fuse(12/24 V)” on page 18
The Vehicle fuse has blown
Replace the vehicle’s 12/24 V
socket fuse(usually 15 A).
Please refer your vehicle’s
operating manual
The display shows an error
message(e.g. “Err1”) and the
appliance does not cool.
The appliance has switched off
due to an internal fault
This can only be repaired by an
authorized repair centre.
