11
10
INSTRUCTION
INSTRUCTION
All models:
Temperature elsewhere in the compartment(sway from centre ) will deviate from displayed temperature.
The freezer starts cooling the interior.
NOTE
When operating with the battery, the display switches off automatically if the battery voltage is low. The LED
flashes orange.
Latching the cooler lid
•
Close the lid.
•
Press the latch(fig
1, page 9) down, until it latches in place audibly.
6.6 Setting the temperature
• Press the “SET” button (fig.
4, page 9)once.
• Use the “UP + (fig.
6, page 9)” and “DOWN –(fig.
7, page 9)” buttons to select the cooling temperature.
• The cooling temperature appears in the display for a few seconds. The display flashes several times then
the current temperature is displayed again.
6.7 Using the emergency switch (where fitted)
The emergency switch (fig.
1, page 10)is located below the control panel. For normal operation the switch
is in the “ NORMAL USE” position.
• If an electronic control failure occurs, slide the switch to “EMERGENCY OVERRIDE” position
NOTE
If the switch is in the “EMERGENCY OVERRIDE” position, the cooler freezes with full cooling capacity.
6.8 Switching off the Freezer
• Empty the Freezer.
• Switch the Freezer off.
• Pull out the connection cable.
If you do not want to use the freezer for a longer period of time:
•
Leave the cover slightly open. This prevents odour build-up.
6.9 Defrosting the cooler
Humidity can form frost in the interior of the cooling devices or on the evaporator. This reduces the cooling
capacity. Defrost the device in good time to avoid this.
NOTICE! Danger of damage!
Never use hard or pointed tools to remove ice or to loosen objects which have frozen in place.
To defrost the freezer, proceed as follows:
• Take out the contents of the cooling device.
• If necessary, place them in another cooling device to keep them cool.
• Switch off the deivice.
• Leave the lid open
• Wipe off the defrosted water
6.10 Replacing the device fuse
DANGER! Danger of electrocution!
Disconnect the connection cable before you replace the device fuse.
• Pull off the connection cable.
• Pry out the fuse insert (fig.
2, page 10) with a screwdriver.
• Replace the defective fuse with a new one that has the same rating
• Press the fuse insert back into the housing.
6.11
Replacing the plug fuse(12/24 V)
• Turn anticlockwise the cap (fig.
1) to move it and pin (fig.
2) from the plug.
• Press one end of defective fuse (fig.
3) with a new one that has the same rating
• Re-assemble the plug in the reverse order.
6.12
Replacing the light PCB
• Pry out the transparent cover with a screwdriver (fig.
1 )
• Unscrew the PCB mounting screws(fig.
2 )
• Pull out the plug from the PCB(fig.
3 )
• Replace the defective light PCB with a new one.
• Fit new PCB using reverse of removal instructions.
• Press the transparent cover back into the housing.
