2.Attach the table legs(B2) using the
stud(G2) on the table top,using wash-
ers and nuts(D,E,F),Tighten using a
wrench and a washer(as a one line
screw driver)(Fig1)
1.Place table top (A2) on a clean soft
surface.
3.Attach the leg support (C2) to the
table leg (B2) using studs(H2),wash-
ers,and nuts(D,E,F).Tighten the nuts
using the wrench.
DO NOT over tighten(Fig.2)
4.Tighten the nuts (H2) on the leg sup-
port
（
C2)using a small wahser(as a
cross screwdriver),Turn the table over
and tighten all of the nuts.
DO NOT over tighten.
5.Adjust the pre-installed Rubber
pads(I)until the table is level with the
ground (Fig.3).Upon completion of full
assembly and bolted up all screws can
be tightened. Then put the caps(J) on
the nuts.
05
02
03
01
04
-11-
