D
E
F
1
1
1
05
02
03
01
04
2.Align the two Studs on the Back-
rest(A1)with the holes in the Chair
Seat(B1).
4.Attach the back legs(C1) to the Studs in the
Chair Seat(B) using Wahsers and
Nuts(D,E,F).Tighten the Nuts using
wrench(H1) .DO NOT over tighten Repeat
this procedure for the front legs(Fig.2)
1.Place all parts on a clean soft sur-
face.
3.Attach the backrest(A1) to the Studs
on the chair seat(B)using Washers and
Nuts(D.E.F),Tighten the Nuts using a
wrench (H1). DO NOT over tighten(-
Fig.1)
5.Adjust the pre-installed Rubber
pads(G1)until the chair is level with the
ground (Fig.3).Upon completion of full
assembly and bolted up all screws can
be tightened down. Put all caps(J) on
the nuts.
-9-
