Outsight creamsource MICRO, Руководство пользователя

Страница: 22 / 36

20
1. Setup as per page 19
2. Point camera directly at Creamsource light
3. Select
MENU->MODES->Calibrate Sync
on Creamsource. It will start to flash
at the locked framerate
4. Use wheel to adjust phase on Creamsource. As you change the phase,
a dark band should appear to move up and down on the camera monitor.
Adjust until the dark band fills the monitor completely. Shooting with wide
shutter angles and at higher speeds reduces the size of the dark band, making
calibration more difficult.
5. The Creamsource is now calibrated. It can be now be set to desired mode
(Normal, Strobe etc) E.g. Select MENU->MODES->Normal
shooting
Once the Creamsource has been calibrated, any of the modes may be used
without the possibility of causing torn frames. The remote dimmer unit or DMX
control can also be used safely. If the framerate, shutter angle or the phase of the
camera shutter is adjusted, then you will need to re-calibrate.
You can use FlashBandit with more than one Creamsource unit only if you are
NOT also using DMX or Remote. This is because the DMX or Remote overrides
the communication channel between the Creamsources.
How to run multiple Creamsource WITH DMX/Remote:
1. You will need a FlashBandit unit for each Creamsource, and each unit will have
to be calibrated (the same Phase angle will apply to all units).
2. Each Creamsource will then need to be set to the desired Mode (Strobe, Flash
Frames etc)
CS_micro_UG_5PRINT.indd 20 11/08/17 1:12 am