3.
Installation
3.2
Insert the micro SIM card
Use the hex wrench to lose 4pcs of hexagon bolts and open the
case.
Insert micro SIM/USIM card (12x15mm) into the SIM card slot.
See chapter 2.2 where is the “SIM card slot”.
Turn on router power switch. See chapter 2.2 where is the
“router power switch”.
Close the case and screw down the hexagon bolts with the hex
wrench.
The micro SIM card is not included in the package.
3.3
Install the aerials
The outdoor router uses 2pcs fiber reinforced plastic (FRP) aerials.
Install mobile phone aerial on the left N-female base connector,
and install another Wi-Fi aerial on the right base connector.
Twist the connector on aerial in clockwise direction to fix them on
the router.
3.4
Connect LAN cable to router
i. Take apart the cable gland, and through the LAN cable.
ii. Plug the RJ45 connector into RJ45 port in the base socket.
iii. Screw on the barrel screw on the base socket.
v. Insert rubber stopper into barrel screw, and crew down the cap.
Take off the cap then unscrew the barrel screw before disconnect
the LAN cable with the router.
3.5
Mounting set installation
3.5.1
L-shape bracket
i. Use the hex wrench to take off the clamp from the router.
ii. Install the L-shape brackets between the router and clamps.
iii. Use the hex wrench to tighten the hex bolts.
3.5.2
Install on a pole
i. Clasp the pole with U-bolts and holders.
ii. Attach the L-shape brackets (installed on the router) on the holders.
iii. Put spring washers, washers, and bolts on U-bolts then tighten
the bolts with a spanner (not included).
Base socket
RJ45
Barrel
screw
Rubber
stopper
Cap
LAN cable
L-shape bracket
Clamp
Hex bolt
U-bolt
Holder
Spring Washer
Washer
Bolt
Pole
L Bracket
