Step 1: Leg Assembly
Step 2: Attach Legs to the Bottom Shelf
Grill Assembly
Locate:
• Left front leg
• Left rear leg
• Right front leg
• Right rear leg
Procedure:
Insert left front leg into right front leg as
shown here. Insert left rear leg into right rear
leg in the same manner.
Note:
The brackets on the lower part of each
pair of legs should face the same side.
Locate:
• Bottom Shelf
• (8) 1/4-20 x .59 Bolts
Procedure:
Align the holes in the brackets of the caster
legs and wheel legs with the holes in the
bottom shelf. Insert the 1/4-20 x .59 Bolts
through the holes in each leg bracket, then
through the holes in the bottom shelf. Leave
the screws loose for now.
5
Assembly Instructions
Follow these step-by-step instructions and you’ll be cooking in no time!
OveRvIew
Some components come pre-assembled, but you will need to complete
the following assembly:
• Connecting the legs
• Attaching the side bars to the legs
• Attaching the wheels and castors to the legs
• Mounting the legs on the grill
• Attaching the side shelf assembly to the grill
• Attaching the door handle to the door
AsseMble The uNIT
Note: The hopper / burner assembly has been mounted to the grill
but is not shown in the diagrams below for clarity.
Unpack the package, and take out the parts, hardware bag and tools.
ConneCT THe LegS
Parts required:
Caster legs (4/5)
Wheel legs (6/7)
Insert wheel leg (6) in caster
leg (4). Insert wheel leg (7)
in caster leg (5).
NOTe: The bracket on the lower part
of each pair of legs should face the
same side.
caster leg
wheel leg
left front leg
axle hole
caster leg side
right front leg
6
ATTACH THe LegS To THe BoTTom SHeLf
Parts required:
Bottom shelf (10)
Hardware required:
8 x Screws 1/4" (34)
Align the holes in the brackets
of the caster legs and wheel
legs with the holes in the bottom
shelf (10).
Insert the 1/4" screws (34) through
the holes in each leg bracket,
then through the holes in the
bottom shelf. Leave the screws
loose for now.
bottom shelf
leg assembly
screw
bracket
ATTACH THe Side BArS To THe LegS
Parts required:
2 x Side bars (11)
Hardware required:
8 x Screws 1/4" (34)
Align the four holes in each side
bar (11) with the holes near the top
of each leg assembly.
Insert a 1/4" screw (34) through
each hole in the side bar, then through
the corresponding hole in the leg
assembly. Leave the screws loose
for now.
screw
side bar
ATTACH THe WHeeLS And CASTerS To THe LegS
Parts required:
2 x Casters (8)
2 x Wheels (9)
Hardware required:
2 x Wheel axles (35)
2 x Axle washers (37)
2 x Axle pins (41)
Tools required:
Open end wrench (42)
