OutBack Power FLEXpower ONE GVFX3524, Руководство по установке

Страница: 18 / 72

Planning
Generator Requirements
IMPORTANT:

All connections must comply with local electric code.

Generator grounding and neutral-to-ground bonding should be
provided in accordance with specific system configuration and
national/local code requirements.

Follow the manufacturer’s recommendations for fuel type and
maintenance.
The following are general requirements for using a generator with the FLEXpower ONE
.

Electrical Requirements
~ North American Applications: 120 Vac / 60 Hz
~ European Applications: 230 Vac / 50 Hz

Minimum available generator power* should be equal to or greater than nominal inverter rating
(*after de-ratings for peak verses continuous power, for load power factor considerations, for
altitude, and for ambient temperature).
~ A generator with a de-rated power specification smaller than that of the inverter may not be
able to handle all downstream AC loads and/or the built-in battery charger.
~ A generator with a de-rated power specification larger that that of the inverter may be
required to handle the built-in battery charger as well as all downstream AC loads.
~ Available power from the generator may be further limited by ratings for circuit breakers
and/or generator output connectors. “Full” generator output power may not be available
from a single generator connector.
~ Generator sizing may be affected by start-up surge current requirements of 3X to 6X normal
operating current for some loads (i.e., motors with large loads).
~ The inverter and/or downstream loads may have difficulty operating from poorly-regulated
generators (voltage, frequency, load).

Grid-interactive inverters typically require inverter-type generators.

Split-phase generators (i.e., 120/240 Vac / 60 Hz) can be adapted to a single-phase inverter using
an autotransformer such as the X-240. For additional information, see…
~ PSX-240 Manual: http://www.outbackpower.com/pdf/manuals/PSX-240_Installation
Manual.pdf
~ X-240 Manual: http://www.outbackpower.com/pdf/manuals/fw-x240.pdf

The OutBack MATE can be used to program an inverter’s AUX output to start and stop a generator.
This 12 V output can often control a two-wire-start generator directly. Three-wire-start generators
require an interface such as an Atkinson module. For additional information, see…
~ OutBack Power Systems AGS Brochure:
http://www.outbackpower.com/pdf/brochures/Automatic_Generator_Start.pdf
~ OutBack Power Systems MATE Manual:
http://www.outbackpower.com/pdf/manuals/mate.pdf
~ Atkinson Electronics: http://atkinsonelectronics.com/
16
900-0095-01-00 Rev A