www.oulighting.com 3
R201110-V12
jack of the solar cell panel.
Important:
If the main unit is mounted horizontally, it must be mounted in a covered area so rain or water cannot get into the unit
through the exposed vents.
▍
FINAL ADJUSTMENT AND START-UP
After you successfully installed your SOLAR PIR SENSOR LIGHT, you are almost ready for carefree operation with a
few final steps:
Initial 3-days Charge:
On the main unit there is a switch with 2 positions:
●
OFF
●
AUTO
Then, turn the slide switch to OFF position. The solar cell will charge the battery without activating the unit. Leave the
switch in this position for 3 sunny days to ensure that the battery has a full charge for motion sensor adjustment and
normal operation.
▍
HOW TO ADJUST THE MOTION SENSOR
After the initial 3-day charge, turn the switch to AUTO position.
On the motion sensor there are three adjusting knobs:
TIME / SENS / LUX
TIME ---
Duration time: For how long you wish the light to run after motion is detected in the field, the duration
time can be adjusted from 10 seconds to 1 minute.
Note:
Once the light is activated by the PIR sensor, any subsequent detection will restart the timed period again from the
beginning.
SENS –
Sensitivity adjustment: The sensitivity of motion sensor can be affected by environmental temperature.
The lower the environmental temperature, the more sensitive the PIR sensor will be. So you can adjust the
SENS knob to compensate for the effects of temperature.
LUX –
Lux control level: The Lux control module has a built-in sensing device (photocell) that detects daylight
and darkness. (
☼
) position denotes that the LED lights will be turned on by PIR during day and night, (
e
)
position denotes that the LED lights will be turned on by PIR only at night. You can set desired level to run the
unit the by adjusting the LUX knob.
Note:
If, in daily position, the unit turns on when it is too light outside, turn the control towards
(
e
)
. However, if the light is not
activating during nighttime because of a street light or bright house light, turn this control towards
(
☼
)
.
Walking Test:
Point the motion sensor to face the area you want to detect motion in and set the TIME knob to minimum (-) position
and LUX knob to “light” (
☼
) position. Walking slowly in its detection area, the sensor can detects moving invisible
infrared radiation given off by a human body and then turn on the light. Test the coverage of the area by walking slowly
around until the sensor can no longer detect your movement.
ADJUSTMENT OF THE LAMP HOUSING:
Point the lamp housing to face the area you wish to illuminate.
▍
TROUBLESHOOTING:
Symptom:
Light won’t activate in normal operation.
Correction:
Make sure that:
1) The main unit switch is the AUTO position.
2) The Lux control is not set too far toward (
e
)
1) The motion sensor is positioned to face oncoming movement
2) The solar cell is angled so that it gets plenty of direct sunlight for most of day, if not the entire day.
3) Battery charge is not too low (charge for 3 sunny days—switch turned to OFF)
Symptom:
Light turns on during the day.
AUTO —
Position for normal operation
OFF ---
1) Position for delivery or long periods of non-use
2) Position for initial 3-day charge before first
adjustment and use.
10
11
12
