www.oulighting.com 2
R201110-V12
GENERAL ELECTRICAL AND SAFETY WARNINGS
1)
The AUTO/OFF switch on the main unit must be in the OFF position when changing the battery.
2)
Do not cut the solar cell wire. Discontinue use if the wire becomes frayed or broken.
3)
Do not immerse components in liquid.
4)
Do not use any other charger than the single solar charging panel provided with the SOLAR PIR SENSOR LIGHT.
This may result in injury or damage to the light and voids any warranty.
5)
Position so that the cord is securely fastened and will not result in a hazard (such as tripping).
6)
When changing the battery, be careful of any sharp edges that could cut you or the wires. Do not pull on the wires.
7)
Do not connect this device to any power source other than what is supplied.
8)
Do not handle the unit with wet hands.
9)
The unit is not waterproof.
▍
COMPONENTS LIST
•
One (1) Main Unit containing 80pcs LED lamp, PIR Motion Sensor, & Battery
•
One (1) Solar Cell Panel
•
Two (2) Main Housing Mounting Screws
•
Two (2) Main Housing Wall Anchors
•
Four (4) Solar Cell Panel Mounting Screws
•
Four (4) Solar Cell Panel Wall Anchors
•
One (1) User Manual
▍
HOW TO DETERMINE WHERE TO MOUNT YOUR SOLAR PIR SENSOR LIGHT
Note:
In the Figure B position, it is important not to let rain enter the main unit. Make sure it is mounted in a covered area.
DIRECT SUNLIGHT is important for the operation of SOLAR PIR SENSOR LIGHT
.
The more direct sunlight the solar cell panel
receives in daytime, the longer the light will operate.
Main Unit:
The main unit contains the lamp (80 pieces super bright white LEDs), PIR motion sensor and battery (
sealed Lead-
Acid Rechargeable battery, 6V, 4AH
). When determining where to mount this unit, please take into consideration
that the motion sensor has a detection scope of min. 20ft / 7m (in front of the light) and about 140º (horizontal) at 25°C
environmental temperature.
To mount the unit vertically as a security light, attach the unit to a solid surface as shown in figure A. To mount the unit
horizontally as convenience lighting, attach the unit as shown in figure B. Use the two wood/ sheet metal screws
provide in the package (#7 on parts list).
Solar Cell Panel:
The solar cell is the main power source for the SOLAR PIR SNESOR LIGHT. It converts the sunlight’s energy into
electricity that charges the battery in the main unit. The Solar Cell Panel requires DIRECT SUNLIGHT for as long as
possible during the daytime.
Use the four wood/sheet metal screws provide in the package (#3 on parts list) to mount the solar cell panel onto a
solid surface. Make sure it is mounted fixed into the solid surface. You can adjust the angle of the solar cell panel by
adjusting the bracket to the appropriate hook on the mounting base. It should face as much DIRECT SUNLIGHT as
possible during the daytime. At
last, route the solar cell panel’s power cord to the main unit and plug it into the side
SOUTH
Figure A
SOUTH
SOUTH
Figure
A
Figure B
