Otto Bock SKIPPI, Инструкция по эксплуатации

Страница: 19 / 68

Information on using the wheelchair control unit: see Page 26.
Troubleshooting information: see Page 60.
Further information on programming can be found in the service manual.
7.2.4.2 Attendant control
The power wheelchair can be ordered and equipped with an attendant control. It may be necessary to fit the
already installed attendant control to the actual body size of the attendant.
Information on operating the attendant control: see Page 44.
Troubleshooting information: see Page 61.
7.3 Adjustments by the user
The power wheelchair is preconfigured on delivery. In the course of use, some settings can be subsequently
changed by the user (see the following sections).
•
Adjusting the armrests (see Page 20)
• Adjusting the lower leg length (see Page 21)
• Adjusting the back angle (see Page 23)
• Adjusting the position of the control panel (see Page 47)
• Adjusting the lap belt (see Page 24)
This fine-tuning should be carried out by attendants and in the presence of the user. The user should be sitting
upright in the power wheelchair during fine-tuning.
All parts of the product should be cleaned thoroughly before adjustments are made.
7.3.1 Safety instructions
CAUTION
Screw connections not tightened
Pinching, crushing, tipping over, falling of user due to assembly errors
► After all adjusting/readjusting work authorised by the manufacturer, retighten the mounting screws/nuts firmly.
Observe any torque settings which may be specified.
7.3.2 Changing control unit parameters
WARNING
Incorrect configuration settings
Falling, tipping over, collision due to programming errors
► Programming may only be performed by qualified personnel trained by the manufacturer. The manufacturer of
the product and the control unit manufacturer are not liable in case of damage caused by programming which
was not performed properly and/or which was not adjusted properly according to the user's abilities.
If necessary, the qualified personnel can adapt the preprogrammed wheelchair control unit and options to the con­
crete requirements of the user.
8 Use
8.1 Circuit breaker
INFORMATION
► Should the fuse burn out repeatedly after a short time for no discernible reason, contact the qualified person­
nel.
►
For shipping or when the power wheelchair is not being used for an extended period of time, the fuse should
be removed.
Note:
The fuse typically comes installed in the dedicated fuse holder when the wheelchair is handed over to the
user.
Before the power wheelchair can be switched on, the fuses may have to be inserted into the fuse holders provided
for the purpose.
They are located on the underside of the battery packs (see fig. 8).
19 Skippi
Use