Otto Bock SKIPPI, Инструкция по эксплуатации

Страница: 25 / 68

60°
90°
18
Positioning the user in the seat
• Place the user in an upright, 90° seated position (if
physiologically possible).
• Ensure that the back is up against the backrest pad­
ding (if physiologically possible).
• The lap belt should be at an angle of about 60° to
90° to the seat surface and run in front of the pelvic
bone.
Possible positioning errors
• The lap belt is positioned above the pelvis of the user in the area of the soft part of the stomach.
• The user does not sit upright in the seat.
• If the lap belt is too loose, the user can shift/slide out to the front.
• During the installation/adjustment, the lap belt is routed over parts of the seating system (e.g. over armrests or
seat pads). This causes the lap belt to lose its retaining function.
19
Adjusting the belt length
1) Position the user in the seat. Follow the positioning
instructions in the previous section to do so.
2) Close the belt.
3) Position the 2 halves of the buckle in front of the
upper body, centred over the thighs.
4) Position the respective half of the buckle at a right
angle (see fig. 19, item 1).
5) Slide the 2 halves of the closure to the desired posi­
tion.
6) Release the respective half of the buckle.
7) Verify the adjustment.
WARNING! The lap belt has to fit closely but
not too tightly so the user is not injured. It
should be possible to slide two fingers com­
fortably between the strap and thigh.
8.6.2 Use
WARNING
Incorrect application
Throttling, suffocation or strangulation due to sliding forward in the product
► The lap belt must be put on when getting into the product and used at all times while using the product.
► Ensure that the buckle lies in the middle of the body.
► Remove any objects or clothing which get caught.
WARNING
Use of the belt system as a restraint system in a vehicle for transporting persons with reduced mobility
is forbidden
Falling out of the product, serious injuries due to improper handling of the product
► Under no circumstances may the belt system be used as part of a personal restraint system for transportation
in a vehicle for transporting persons with reduced mobility.
► Note that the belt system is only intended as additional stabilisation for the user sitting in the product.
25 Skippi
Use