Otto Bock SKIPPI, Инструкция по эксплуатации

Страница: 20 / 68

8
Installing the fuse
1) Remove the battery packs (see Page 36).
2) Remove the fuse from the supplied protective cover.
3) Insert the fuse into the slot provided (see fig. 8).
4) Reinstall the battery packs (see Page 36).
Removing the fuse
>
Prerequisite:
The control unit is switched off.
1) Remove the battery packs (see Page 36).
2) Take the fuse out of the slot (see fig. 8).
3) Reinstall the battery packs (see Page 36).
8.2 Side panels
INFORMATION
For additional information on side panels with lighting: see Page 48.
INFORMATION
Additional information for adjusting the control panel position: see Page 47.
The side panels protect the user and his/her clothing from getting dirty.
The installed armrests offer the user additional support for the forearms.
8.2.1 Removing/installing the side panels
To make getting in from the side easier or for transportation, the side panels can be removed if needed.
9
Removing the side panel
1) Loosen the wing screw on the side panel holder
(see fig. 9).
2) Pull the side panel out from the side panel holder
and set it aside.
3)
Only for side panel with control panel
:
→ Carefully let the side panel with the control pan­
el hang down while getting in.
→
For transporting the power wheelchair, place
the side panel on the seat.
Installing the side panel
1) Insert the side panel into the side panel holder.
2) Re-tighten the wing screw on the side panel holder
(see fig. 9).
8.2.2 Adjusting the Side Panels
The height and depth of the armrests can be adapted to the requirements of the user.
20
Use
Skippi