Otto Bock SKIPPI, Руководство по обслуживанию

Страница: 54 / 72

enAble40 wheelchair control – installation and programming
Skippi 54 | Ottobock
8.4.5 Hand Controls Menu
The three parameters in the “Hand controls” menu refer to the hand control device and at-
tendant controls. This menu is followed by four sub-menus that refer to the following control
devices: Speed Mode, Joystick, Sound & Display and Charger.
Parameter Allowable
Range
Description
Auto Shutoff 0 – 60 min After this period of inactivity, the power wheelchair is automatically
turned off. A value of 0 deactivates this function.
Key Lock
Function
0, 1, 2 Establishes how a locked system can be reactivated. A value of 0
deactivates this function.
Push and hold the On/Off button on one of the two control devices
for at least 2 seconds. When the button is released, the system
shuts off and the drive-away lock is activated.
Cancelling the drive-away lock depends on the setting of the Key
Lock Function parameter.
When it is set to 1, you have to press the horn button during the ac-
tivation test of the LCD. (The regular sound of the horn is replaced
by a short beep.) If this process was not completed successfully,
only the key symbol is shown on the display after the activation test
is complete in order to indicate that the drive-away lock is still ac-
tive. In order to cancel the drive-away lock, you have to turn off the
system and carry out the start-up sequence again.
If the parameter is set to 2, you have to move the joystick as follows
during the activation test of the LCD: Push the joystick forward until
you hear a beep, then backward until you hear a beep and finally to
the centre until you hear a beep. If this process was not completed
successfully, only the key symbol is shown on the display after the
activation test is complete in order to indicate that the drive-away
lock is still active. In order to cancel the drive-away lock, you have
to turn off the system and carry out the start-up sequence again.
Attendant
Takeover
1, 2 Determines if the hand controller can turn off the system when the
attendant control unit is active.
When the parameter is set to 1, the attendant control unit is the
master and the hand controller cannot turn off the system.
When the parameter is set to 2, the hand controller can turn off the
system even if the attendant control unit is turned on.