Otto Bock Otto Bock Back 1, Руководство пользователя

Страница: 6 / 77

1
English
Otto Bock Back 1
Otto Bock Back 2
Otto Bock Back 3
Otto Bock Back 4
Otto Bock Breathable™ Back
By Otto Bock HealthCare
Intended Use and Descriptions
Otto Bock’s family of wheelchair back cushions are used to improve the seated posture of
the user, as well as to provide pressure relief, by properly supporting the trunk region and
distributing existing pressure over the largest possible area.
Application
Improved thoracic lateral support if the user’s sitting posture requires additional support.
Support for an orthopedic deformity such as a lordosis, can be inserted in a compartment
between the solid base and the pad.
Using the integrated FLOAM® pads for Back 2, Back 3 and Back 4 in the vertebral region
can reduce risk of decubitus ulcers.
The Otto Bock warranty applies only when the product is used according to the specified
conditions and for the intended purposes, following all manufacturers’ recommendations
(see 2-Year Limited Warranty section for more details).
INSTRUCTION MANUAL
BEFORE YOU BEGIN:
Tools Needed:
Phillips head screwdriver.
Soft-headed hammer: optional width adjustment.
Drill with 1/4˝ (6 mm) bit: for use in attaching optional headrest.
Preparing the Wheelchair:
Remove the upholstery from the back of the wheelchair’s push canes per manufacturer’s
instructions.
Definitions as Used in this Manual:
1. B1 (Back 1)
2. B2 (Back 2)
3. B3 (Back 3)
4. B4 (Back 4)
Installing the Otto Bock Back Cushion to the Wheelchair
A. Connecting the Rigid Back Bracket to the Wheelchair Push Canes
1. Determine the diameter of the wheelchair push canes.
2. The rigid back bracket will accommodate 3/4˝, 7/8˝, and 1˝ (19-20 mm) push canes
(Figure 1). Hold the Back in the location it will be installed on the wheelchair and
place a mark on both push canes to indicate the location for the bracket tape. (This
location is about 1/4˝ (6 mm) below the rigid back bars).
3. Remove the rigid back bracket screw and attach the rigid back bracket around the
wheelchair push canes as shown in Figure 2.
4. Make sure that the left and right rigid back brackets are the same height on the
wheelchair push canes before tightening.
5. Re-insert the rigid back bracket screw and tighten as shown in Figure 2A, 2C, 2D.
1