Otto Bock Motus CS, Инструкция по эксплуатации

Страница: 21 / 36

INFORMATION
Ensure that the user’s pelvis is positioned as far back in the wheelchair as possible, i.e. between the back sup­
port tubes.
The back support upholstery can be adapted in segments to the needs of the user (see fig. 38).
1) Remove the back support pad (see fig. 30).
2) Loosen the hook-and-loop fastener of the upholstery straps (see fig. 39, item 1; see fig. 40, item 1).
3) Fasten the upholstery straps with the desired tension using the hook-and-loop fastener.
If necessary, thread the upholstery straps in/out of the flaps to do so (see fig. 39, item 2).
4) If the upholstery straps are too long, they can be shortened. To do so, remove the end pieces from the uphol­
stery straps (see fig. 41, item 1), trim the upholstery straps (see fig. 41, item 2) and reattach the end pieces.
5) Put on the back support pad and attach it with the hook-and-loop fastener. Make sure the fold lies flush over
the upper edge of the back support (see fig. 42).
38 39
40 41
42
6.6.1.2 Back upholstery, standard
Removing the back support upholstery
1) Open the hook-and-loop closures on the back support upholstery (see fig. 43, item 1).
21 Motus CV, Motus CS
Settings