Otto Bock Motus CS, Инструкция по эксплуатации

Страница: 19 / 36

5) Insert the mounting screws into the frame tube and tighten to
7 Nm
.
→
Both back support tubes must be adjusted to the same height.
Properly reassemble all components upon completion of the adjustments. To adjust the back support upholstery:
see page 20.
30 31
32
6.5.2 Adjusting the back support angle
WARNING
Missing anti-tipper
Tipping over, falling of the user due to missing safety devices
► If the back is tilted far to the rear and in the case of a short wheelbase, 2 anti-tippers (one on each side) must
be mounted and in a functional position; in the case of a long wheelbase, at least one anti-tipper must be
mounted and in a functional position.
► Check that the anti-tipper is securely attached.
The product can be equipped with a fixed, angle-adjustable or folding back support.
Angle-adjustable back support
With this option, the back support angle is continuously adjustable from
90° to 120°
in increments of
10°
(see
fig. 33).
1) Pull the cable of the back release mechanism until the locking pins release the angle adjustment (see fig. 34,
item 1).
2) Move the back support to the desired position.
3) Release the cable. Ensure that the locking pins securely engage on both sides.
19 Motus CV, Motus CS
Settings