Otto Bock Invader 480S26-20000_K, Инструкция по эксплуатации

Страница: 15 / 36

7.6.1 Fastening/removing the backrest pad
The backrest pad can be removed for cleaning.
1) Remove the seat cushion from the seat pad.
2) Pull the lower end of the backrest pad off the hook-and-loop fastener on the seat pad (see Fig. 13).
3) Pull the back padding up and off (see Fig. 14).
4)
After cleaning (see Page 26): Put the back padding back onto the back upholstery. Position the seam of the
backrest padding exactly over the upper upholstery strap (see Fig. 15, item 1).
5) Pull the backrest padding down and attach it to the hook-and-loop fastener on the back upholstery.
6) Attach the lower end of the backrest padding to the hook-and-loop fastener on the seat pad (see Fig. 16).
INFORMATION: This prevents sliding and protects against draughts.
7) Fasten the seat cushion to the hook-and-loop fastener on the seat pad.
13 14
15 16
7.6.2 Adjusting the back upholstery
The back upholstery is attached to the frame tubes with hook-and-loop straps.
1) Fold up the backrest padding.
2) Open and loosen the hook-and-loop straps one after the other (see Fig. 17).
3) Sit and position the user in the wheelchair.
4) From the bottom to the top, adjust the tension of the hook-and-loop straps to the weight and anatomical condi­
tion of the user and fasten the straps (see Fig. 18).
INFORMATION: The two ends of the hook-and-loop strap have to overlap by at least 100 mm in each
case.
INFORMATION: Adjust the respective lower hook-and-loop straps somewhat tighter.
INFORMATION: Deviating adjustments may be required in specific cases; this is the responsibility of
the attending therapist.
Ottobock | 15 Invader 480S26=20000_K
Use