Otto Bock Avantgarde XXL 2, Инструкция по эксплуатации

Страница: 18 / 32

2) Loosen the hook-and-loop fastener on the underside of the seat upholstery.
3) Adjust the seat upholstery tension.
4) Close the hook-and-loop fastener.
5) Unfold the wheelchair. In doing so, the crossbrace must seat fully in the support guides.
23
6.7 Adjusting the leg supports
6.7.1 Adjusting the lower leg length
The required leg support height depends on the lower leg length of the user and the thickness of the seat cushion.
Adjusting the height of the angle-adjustable leg support and segmented leg support
1) Loosen the set screws on the locking mechanism (see fig. 24, item 1).
2) Adjust the lower leg length (continuously adjustable). Ensure that the foot plate bar (see fig. 24, item 2) is inser­
ted into the swivel segment (see fig. 24, item 3) by at least
40 mm
.
INFORMATION: A mark on the foot plate bar indicates the minimum distance the foot plate bar must
be inserted during installation.
3) Tighten the set screws on the locking mechanism to
8 Nm
.
Adjusting the height of the amputation leg support
1) Open the Allen head screws and move the leg support to the desired height (see fig. 25).
2) Tighten the Allen-head screws.
24 25
6.7.2 Adjusting the support angle
The leg support angle setting should be chosen so that the ankle is in a relaxed, comfortable position.
1) Loosen the Allen head screws on the rear foot plate suspension by several turns (see fig. 26).
2) Turn the foot plate to the desired angle.
3) Tighten the Allen head screws to
10 Nm (see fig. 26).
18
Settings
Avantgarde XXL 2