Otto Bock Avantgarde Teen2 T, Инструкция по эксплуатации

Страница: 13 / 32

8 9
6.3.2 Changing the installation position of the caster wheels
The seat height/angle can be retroactively adjusted through repositioning of the casters in the caster forks or use of
different wheel sizes.
Please refer to the installation matrix in the section "Technical data" for permitted positions and combinations of
rear and caster wheels.
1) Unscrew the screw connection of the threaded axle (see fig. 10).
2) Remove the threaded axle/spacers.
3) Remove the caster wheel.
4) Insert the threaded axle with the first spacer bushing offset in one of the four bore holes.
5) Install the caster wheel.
6) Push on the 2nd spacer bushing (see fig. 11, item 1).
7) Tighten the threaded axle to
8 Nm
.
→ Once changed, the left and right caster wheels must have the same vertical position in the caster fork.
10 11
6.4 Adjusting the wheel locks
WARNING
Failure to verify brake functionality
Accident, falling of the user due to incorrect adjustment
► Check the correct spacing between the wheel lock bolt and tyre (see the following section for details).
► Check the correct position of the wheel lock bolt relative to the tyre. During braking, the wheel lock bolt has to
cover at least half the tyre width.
► Always carry out adjustments to the wheel lock on both sides.
► Ensure that the user can operate the wheel lock without great effort. The force required to do so must not
exceed
60 N
.
►
Only use original drive wheels with a verified maximum radial out-of-round of 1 mm .
This adjustment must be made after the drive wheel has been repositioned or during fine adjustment.
13 Avantgarde Teen2 T,
Avantgarde Teen2 VR
Settings