Otto Bock Avantgarde CLT, Руководство по обслуживанию

Страница: 45 / 64

159 160
3.12.6.3 Tensioning the spokes; adjusting the out-of-round
Tensioning the Spokes
1) Completely remove the tyre (see fig. 157).
2) Check the spoke tension by shaking/moving the spokes.
3) If necessary, carefully adjust the tension of the spokes with spoke tensioner.
4) Completely reinstall the tyre.
Adjusting the Out-of-Round
Adjusting the out-of-round by a maximum of
1 mm
requires special instruments and technical knowledge. The
adjustment should be performed in a bicycle specialist workshop.
3.12.6.4 Adjusting the Quick-Release Axle
The quick-release axle (see fig. 161) should be adjusted so that it engages properly and so that the wheel has no
play on the axle.
1) Hold the tip of the quick-release axle with a wrench (size 11).
2) Adjust the play by turning the nut on the end of the quick-release axle (size 19; see fig. 161, item 1) in or out.
161 162
3.12.6.5 Retrofitting the Tetra Axle
1) Remove the quick-release axle with rear wheel.
2) Exchange quick-release axle for tetra axle.
3) Insert rear wheel with tetra axle into the fitting.
45 Avantgarde CV / CS / CLT
Service Work