Otto Bock 8K26, Инструкция по эксплуатации

Страница: 12 / 104

12 | Ottobock
4 Handling
4.1 Assembly
The System Hands –voluntary closing– are to be mounted to an Ottobock
wrist unit.
For long below-elbow and through-wrist residual limbs, the chassis with
threaded stud must be replaced by the chassis with 9E94=* Lamination
Ring as follows:
9S96=40 for hand size L/R 6 ¾
9S184=* for hand sizes L/R 7 ¼, L/R 7 ¾, and L/R 8
The parts are attached with the 506G4=* Set Screw (Fig. 1).
The 640F18 Donning Spray facilitates the application of the inner hand
on the System Hand.
To avoid any damage, use the 711M1 Hand Holding Tool for holding the
System Hand while pulling on the glove. The 711M2 Mounting Plate is used
for attaching the Hand Holding Tool to a workbench (Fig. 2).
4.2 Combination possibilities
The Ottobock System Hands –voluntary closing– can be combined with
the adapters of the field of modular arm prostheses and with the Ottobock
wrist units.
It may be necessary to select a suitable adapter from the wrist unit
accessories.
5 Legal information
All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
5.1 Liability
The manufacturer will only assume liability if the product is used in accor-
dance with the descriptions and instructions provided in this document.
The manufacturer will not assume liability for damage caused by disregard
of this document, particularly due to improper use or unauthorised modi-
fication of the product.
5.2 CE conformity
This product meets the requirements of the European Directive 93 / 42 / EEC
for medical devices. This product has been classified as a class I device