Otto Bock 1M10 Adjust, Инструкция по эксплуатации

Страница: 10 / 144

10
axial joint in the load line. The heel characteristics can be individually adapted with a function
module.
1.2 Combination possibilities
This prosthetic component is compatible with Ottobock's system of modular connectors. Func­
tionality with components of other manufacturers that have compatible modular connectors has
not been tested.
2 Intended use
2.1 Indications for use
The product is intended exclusively for lower limb exoprosthetic fittings.
2.2 Area of application
Our components perform optimally when paired with appropriate components based upon weight
and mobility grades identifiable by our MOBIS classification information and which have appro­
priate modular connectors.
m°
kg
The product is recommended for mobility grade 1 (indoor walker) and mobility
grade 2 (restricted outdoor walker).
Maximum body weight
Size [cm] 22 to 23 24 to 25 26 to 27 28 to 30
Stiffness 1 52 kg 58 kg 72 kg 77 kg
Stiffness 2 68 kg 76 kg 95 kg 100 kg
Stiffness 3 80 kg 100 kg 125 kg 125 kg
2.3 Environmental conditions
Storage and transport
Temperature range –20 °C to +60 °C (–4 °F to +140 °F), relative humidity 20 % to 90 %, no mechanical
vibrations or impacts
Allowable environmental conditions
Temperature range:
–10 °C to +45 °C
Moisture: relative humidity: 20% to 90%, non-condensing
Chemicals/liquids: fresh water as dripping water, occasional contact with salty air (e.g. near the ocean)
Solids:
dust
Prohibited environmental conditions
Chemicals/moisture:
salt water, perspiration, urine, acids, soapsuds, chlorine water
Solids: dust in high concentrations (e.g. construction site), sand, highly hygroscopic particles (e.g. talcum)
Other environmental conditions
UV light
Not resistant
Hydrolysis Not resistant
2.4 Service life
This product has been tested by the manufacturer with 2 million load cycles according to ISO
22675. Depending on the patient's activity level, this corresponds to a service life of 2 to 3 years.