OTT MF pro, Руководство по эксплуатации

Страница: 11 / 40

Product components
When purchasing a complete system, refer to Figure 4 to make sure that all components have been
received. If any of these items are missing or damaged, contact the manufacturer or a sales
representative immediately.
Figure 4 System components
1 Carrying case (with slot for sensor cable) 8 Universal sensor mount
2 USB cable with mini-USB connector, 1 m (3 ft) 9 Velcro strap
3 Adjustable portable meter mount 10 Lanyard
4 Battery charger, 100–240 VAC 11 Portable meter
5 Sensor 12 Lithium battery pack
6 Extra thumb screws (4x) 13 Sensor as connected to meter inside case
7 Cloth to dry the sensor
Installation
Installation with optional accessories
Mount the meter on an optional wading rod for use in low-stage stream environments where the
stream can be waded. Optional accessories let the user take measurements from a bridge or cable
over a stream. A torpedo shaped weight attached below the sensor keeps the sensor in place when
under water. For more information, refer to the documentation supplied with the accessory.
Install the sensor on the universal sensor mount
Use the universal sensor mount to attach the sensor to poles 1 inch or less in diameter. For correct
operation and accurate readings, the front of the sensor must be pointed upstream with the
electrodes in full contact with the flow.
Note: Keep the sensor electrodes free from nonconductive substances such as oil and grease. To remove sensor
contamination, refer to
Clean the sensor on page 28.
1. The front part of the sensor is round and contains three electrodes. The sensor has a mounting
hole in back and a thumbscrew on top. Put the mounting shaft of the universal mount in the
English 9