OTOLIFT 87, Функциональность и устранение неполадок

Страница: 13 / 42

13
6. Charging the batteries
If the chairlift is on, and the batteries are being charged, the LED on the armrest is on continuously.
When the chair is on and the batteries are NOT being charged the LED will blink with a frequency of
1 Hz.
6.1 Charging-points
The voltage for charging the batteries is interconnected through the charging contacts.
A detail drawing of the connections of the charging-points is attached. (drawing
86900 LD eng)
6.2 No-charging-alarm
When the lift is not moving and is not receiving any charging voltage, the lift will start beeping after
15 seconds or 2 minutes.
Frequency of the beep = 1Hz
If the lift gives the no-charging-alarm you can stop this alarm by controlling left or right for 0,5
second. (remote or armrest).
When the lift has been used, and the batteries are still not charged after it stopped, the alarm will
sound again.
The time to no-charging-alarm can be set by dipswitch 6.
6.3 Transformer / on board charging-circuit
The main PCB has its own charging-circuit on board.
Because of this we can charge more accurate, which results in a longer lifetime of the batteries.
The maximum charge-current is 1,1A .
The transformer of the type 87 is NOT a battery-charger. You can not and may not use this
transformer for charging batteries directly.
Only use this transformer in combination with the 86900 or 09000 (jade) PCB.
Visa versa, you can not use a standard battery-charger, to charge the batteries when a type 86 main
PCB is connected.
The transformer must be fused with a 1,6 Ampere Fuse (glass-fuse 5x20)
NEVER apply a fuse with a higher value.
Always use the special 24V DC transformer which is delivered by Otto Ooms BV.