16
Page
OPERATOR CONTROL PANEL
The operator control panel mounts to the fiberglass body using a bolt, nut, and washer at
the top end (between the seats) and using either a bolt or sheet metal screw at the bottom
edge near the floor. Remove the upper bolt first. Then remove the bottom fastener- it
screws into a captive Tinnerman U-type self-retaining speed nut on the inside lip behind
the fiberglass. When the bolts are removed, lift up on the panel about ½- inch so the
bottom lip clears the fiberglass. The panel may then be pulled forward a few inches for
access to the components mounted on it. The heavy battery cables and studs on the
reversing switch may hang up on the fiberglass but a little patience and care will free the
panel for maintenance.
Bottom end of
control panel
Fastener
Lip part of control panel
Tinnerman speed nut
Fiberglass body (partial)
