OTARI MX-5050MKIII-2, Руководство по эксплуатации

Страница: 21 / 48

13 MONITOR SOURCE/ In the "out" (SOURCE) position, the
TAPE Switch input signal is fed to the LINE OUT
connectors, the PHONES jack, the VU
meters, and the peak indicators.
In the "in" (Tape) position, the
signal being reproduced is fed to
the LINE OUT connectors, the PHONES
jack, VU meters, and the peak
indicators.
14 EQ Selection
Located on the amplifier front panel
Indicator are 2 LED EQ Selection Indicator
Displays which indicate the position
of the NAB or IEC EQ switch which is
located on the back of the unit.
15
Record Level Located on the front amplifier front
Selection
panel are 3 LED Record Level Se-
Indicator lector Indicator Displays which
indicate the position of the Record
Level Selector switch which is
located on the back of the unit.
3.2 OPERATING INFORMATION
3.2.1 USE OF THE REEL HOLD DOWN KNOBS
W NAB hub reel hold down knobs are used as follows:
When an EIA hub (2-1/4 inch diameter hub) is used;
(1) Remove the NAB reel hold down knob by turning the inner knob
counterclockwise.
(2) Place the reel on the reel table.
(3) Place the reel hold down knob on the reel and fix it by turn­
ing the inner knob clockwise.
NOTE: ZA-52Y optional accessory (see page 1-4) is recom-
mendable to hold 2-1/4 inch diameter hub.
When an NAB hub (4-1/2 inch diameter hub) reel is used;
(1) Place the reel hold down knob on the reel table and lock it
by turning the inner knob clockwise.
(2) Place the NAB hub reel on to the reel table and fix it by
pulling and turning the outer knob.
3-9