www.oster.ca
www.oster.ca
8
9
How to Blend Using the To-Go-Cup and Blending Base
NOTE: If unit is assembled as a juice extractor, please
follow the instructions in the section ‘DISASSEMBLE
YOUR JUICE EXTRACTOR”
1 Place the To-Go-Cup without the lid on a flat dry
surface with the open-end facing up (Figure 1)
and fill it with all the desired ingredients.
2 Place the blender assembly with blade upside
down on top of the To-Go-Cup opening,
aligning the locking tabs (Figure 2).
3 Turn the blender assembly
to lock it securely
(Figure 3)
4 Turn it upside down to be placed on the motor
base (Figure 4).
5 Align the arrows located on top of the motor
base with the grooves located on the blender
blade assembly (Figure 5).
6 Raise the safety locking arms, and then lower
them to securely fit into the grooves and press
to lock (Figure 6)
7 Turn the on/off switch on the front of the unit to
on (“I”) position and blend until mixture reaches
desired consistency.
8 When done, turn the on/off switch “I/O” to the
off (“O”) position.
9 Unlock the safety locking arms to release the
blade assembly with To-Go-Cup (Figure 7).
10 Lift the blender assembly with To-Go-Cup up
and flip it (Figure 8).
11 To remove blender assembly, turn it
to unlock it
and lift it up (Figure 9).
12 Screw on spill proof drinking lid on To-Go-Cup
(Figure 10).
Figure 1
Figure 2
Figure 3
Figure 4
Figure 9
Figure 10
Figure 8
Figure 6
Figure 7
Figure 5
Groove
Motor base and
blender assembly
alignment
