www.traxontechnologies.com | www.osram.us/traxon
©2021 TRAXON TECHNOLOGIES - AN OSRAM BUSINESS. ALL RIGHTS RESERVED. TRAXON™, TX CONNECT®, ARE TRADEMARKS OF TRAXON TECHNOLOGIES. U.S. PATENTS, E.U. PATENTS, JAPAN PATENTS, OTHER PATENTS
PENDING. SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
Installation Guide
V1.0 12/21
P. 9 of 20
3.2.3
Installation Sequence
1. Measure the correct distances for brackets and install the Allegro Media Tube
®
Lite fixtures.
2. Connect the Allegro Media Tube
®
Lite in the daisy-chain manner outlined in the System Diagram to form large
installations.
3. Perform functional check on all the Allegro Media Tube
®
Lite and inspect cables and brackets for any
damage. Check for any abnormalities with the control signal.
4. Report any functional defect found to your nearest Traxon Technologies office. DO NOT attempt to install the
Allegro Media Tube
®
Lite with functional defects on-site.
3.3 On-Site Installation
•
DO NOT attempt installation in wet or severe weather conditions.
•
DO NOT leave and expose any Allegro Media Tube
®
Lite or LED Engines
unconnected under wet/raining or snowing environment.
•
IP failure induced by stressed/damaged cables during or after installation
will not be under warranty by Traxon Technologies.
•
ALWAYS keep the cables protected from sharp objects and ensure no
damage is generated on the cable.
Failure to keep Allegro Media Tube
®
Lite within the operating temperature range of
–40°C to +50°C / –40°F to
+122°F
and storage temperature range of –40°C to +70°C / –40°F to +158°F will void the product’s warranty.
3.3.1
On-Site Installation
1. Fix brackets to installation surface with anchor bolts or screws (by others).
2. The Allegro Media Tube
®
Lite are interconnected using the IN and OUT cables/connectors on each end of
the tube. Connectors will make an audible “click” when connected. Gently pull on the cables in opposites
directions to ensure they are fully locked and do not come loose. The below diagram shows the Tube
connections. Always remember to affix a Quick Lock Waterproof End Cap (sold separately) for the OUT
connector of the final Tube in each daisy chain. See System Diagram for details.
FIG.7: Allegro Media Tube
®
Lite Connections
Starter Cable
End Cap
NOTE: Any water ingress incurred due to improper installation of cable connectors or Waterproof Quick Lock
End Caps will not be covered under warranty by Traxon Technologies.
