Osram AB465960038, Руководство по установке

Страница: 16 / 62

16
Setup Manual - LIG
9 Additional configuration settings
Using the LIG Configurator, you can configure additional settings for the
LIG.
y
Dimming unused lightbars: only the bar for the current active Scene is at full
intensity, all unused bars are dimmed.
y
Start and end values for DMX channels in the Zones can be defined freely.
10 Power supply
The LIG is powered by a 24 V DC external power supply or via standard
Power over Ethernet (PoE). It is also possible to power the LIG via the USB
interface. This is only recommended when updating the firmware of the device and
no external power supply is available.
i
The LIG requires up to 500 mA supply current from
the USB interface (USB 2.0). Make sure that the power source
can provide this current.
11 Standard use
The LIG controls up to two DMX universes. This address range is split into
three Zones. To any Zone a Scene can be assigned, a Scene can be a constant color
or effect, and a brightness level. To select Zones and assign Scenes, touch-sensitive
button are used. To change the brightness turn the jog wheel. To switch the LIGHT-
DRIVE+ on and off, press the jog wheel. The color in the current selected Zone is also
used to illuminate the jog wheel while it is not in dimmed or sleep mode.