AirZing™ PRO 5030 UNIV
IMPORTANT SAFEGUARDS.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
PRIOR TO INSTALLATION AND USE.
SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE.
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including
the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
a) This equipment is designed for use with germicidal UV radiation sources and must be
installed in compliance with competent technical directions to prevent risk of personal injury
from UV radiation.
b) UV radiation can pose a risk of personal injury. Overexposure can result in damage to eyes
and bare skin. To reduce the risk of overexposure this equipment must be installed in
accordance with the manufacturer’s site planning recommendations. This may include
instructions on the relative location of each germicidal system component, the minimum
distances between UV-generating devices and other objects or surfaces, and protection from
line-of-sight exposure to UV radiation in occupied spaces located above the equipment
mounting area (e.g. upper floor balconies, open staircases, etc.)
c) UV and optical radiation can be reflected by surrounding surfaces such as ceilings and walls.
Since the reflective properties of surfaces can vary widely, it should be considered as part of
site planning. Follow the manufacturer’s recommendations for selecting appropriate ceiling
and wall finishes.
d) IT IS THE RESPONSIBILITY OF THE INSTALLER TO ENSURE THAT PERSONS WILL NOT BE
EXPOSED TO EXCESSIVE UV OR OPTICAL RADIATION DURING EQUIPMENT OPERATION.
THIS WILL REQUIRE THE INSTALLER TO CONDUCT AN ASSESSMENT OF IRRANDIANCE OR
ILLUMINANCE LEVELS IN THE SURROUNDING OCCUPIED SPACES PRIOR TO OCCUPANCY.
e) Equipment should be mounted in locations and at heights where it will not readily be
subjected to tampering by unauthorized personnel.
f) Maintenance and servicing of this UV generating equipment shall be performed by authorized
personnel. Service personnel must wear appropriate Personal Protective Equipment (PPE) if the
equipment will be in operation during the maintenance or servicing work. Contact the equipment
manufacturer for PPE recommendations and guidance.
g) When replacing lamps, replace them only with the lamps for which the equipment is marked
and intended.
h) The use of accessory equipment not recommended by the manufacturer may cause an unsafe
condition.
i) Do not use this equipment for other than intended use.
CAUTION – This product is for restricted access usage only.
SAVE THESE INSTRUCTIONS
