© Office Star Products April 2012
IMPORTANT NOTE:
1. Use hand tools only for assembly as power tools may cause damage
2. Carefully remove any staples used for packaging.
STEP 1
STEP 2
2
3
5
5
4
10
10
9
9
8
7
6
6
1
PART QTY
1.
Chair Back . . . . . . . . . . . . . . . . . . . 1
2.
Seat Frame . . . . . . . . . . . . . . . . . . 1
3.
Right Front Leg . . . . . . . . . . . . . . . 1
4.
Left Front Leg . . . . . . . . . . . . . . . . 1
5.
Flat Washer . . . . . . . . . . . . . . . . . . 9
6.
Lock Washer . . . . . . . . . . . . . . . . . 9
7.
Short Screw . . . . . . . . . . . . . . . . . . 5
8.
Long Screw . . . . . . . . . . . . . . . . . . 4
9.
Dust Barrier . . . . . . . . . . . . . . . . . . 1
10.
Allen Wrench . . . . . . . . . . . . . . . . 1
Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.
STEP 1
Place Chair Back (1) on a soft surface . Align the holes on the Chair Back (1) with the holes on the Seat Frame (2) . Secure the
Seat Frame (2) to the Chair Back (1) using five Flat Washers (5), five Lock Washers (6) and five Short Screws (7),
AS SHOwN IN DETAIl A. TIGHTEN All SCREwS USING AllEN wRENCH (10).
STEP 2
Attach Right Front Leg (3) and Left Front Leg (4) to Seat Frame (2) using two Flat Washers (5), two Lock Washers (6) and using two
Long Screws (8) for each leg.
SEE DETAIl B
.
DO NOT FUllY TIGHTEN SCREwS.
Turn chair to the upright position, apply firm pressure to align
and
FUllY TIGHTEN All SCREwS USING AllEN wRENCH (10),
Secure Dust Barrier (9) to bottom of Seat Frame (2) using pre-installed
hook and loop material.
ATTENTION: MAKE SURE All SCREwS ARE FUllY TIGHTENED BEFORE USING CHAIR.
MET88ES/CM/RD
PARSONS CHAIR w/ BUTTON BACK
ASSEMBlY INSTRUCTIONS
DETAIl A
DETAIl B
