4
1.3 Safety instructions for installers
!
WARNING
The overflow from the safety valve must NOT be sealed or plugged.
Fitting an external control unit managing the power supply to the product is NOT allowed
without approval from the manufacturer.
!
Any overflow pipe from the safety valve MUST be >1/2 mm inside, clear, undamaged and
frost-free with a fall to the drain.
!
Fixed electric fittings shall be used for installation in new homes or when changing an
existing electrical setup in accordance with regulations.
!
The mains cable shall withstand 90°C. A strain reliever must be fitted.
!
The product shall be filled with water before the power is switched on.
!
The relevant regulations and standards, and this installation manual, must be followed.
1.2 Safety instructions for users
!
WARNING
The overflow from the safety valve must NOT be sealed or plugged.
The product must NOT be covered over the cover on the front.
The product must NOT be modified or changed from its original state.
Fitting an external control unit managing the power supply to the product is NOT allowed
without approval from the manufacturer.
Children must NOT play with the product or go near it without supervision.
!
The product shall be filled with water before the power is switched on.
!
Maintenance/settings shall only be carried out by persons over 18 years of age, with sufficient
understanding
!
CAUTION
The product must not be exposed to frost, over-pressure, over-voltage or chlorine treatment.
See warranty provisions.
Maintenance/settings shall not be carried out by persons of diminished physical or mental
capacity, unless they have been instructed in the correct use by someone responsible for their
safety.
!
CAUTION
!
The product shall be fitted in accordance with Part G3 of building regulations.
Liability for consequential damage will only apply if this is followed.
!
The product shall be properly aligned vertically and horizontally, on a floor or wall suitable for
the total weight of the product when in operation. See type plate.
!
The product shall be mounted to allow access to the junction box when needed.
