Osmo Wood Orbiter, Руководство по эксплуатации

Страница: 11 / 12

11
6. Wash the brushes either in a bucket or under running water.
7. Before you position the Orbiter on its side it is important to remove the Bowden cable and the water hose from the
fresh water tank.
8. Position the Orbiter on its side and wipe the drum dry using a cleaning cloth.
The Orbiter can be cleaned with a hose and brush in outdoor areas.
9. Reinsert the brushes by reinserting the floating axles from the right.
Repair
To ensure the long term enjoyment of the Osmo Wood Orbiter, please observe the following points:
- Clean the brushes on a regular basis. Do not use a high-pressure or steam cleaner.
- Ensure that the machine is not resting on the brushes when it is not in use.
Always store your additional brushes in an upright position.
- Swap the front brush with the rear brush on a regular basis or turn them if necessary.
In case the bristles should become hard, allow the machine to run shortly over a concrete or stone surface.
1. Ensure that the filter in the fresh water tank is kept clean. For this, push the end of the Bowden cable into
the filter holder and turn it anti-clockwise, clean it under running water and then reinsert.
2. Always keep the nozzles clean.
Pull
Push