USER MANUAL FOR THE OSMIO INFINITY HYDROXY GAS/WATER PRODUCTION ELECTROLYSIS SYSTEM
8
2.1
Power Safety
●
For use only with a standard UK 220
–
240 Volt three pin plug
●
Plug into an earth bonded, RCD (Residual Current Device) protected circuit
●
Use in a grounding socket with rated current above 10 Amps
●
Do not use if the power cord/plug is damaged, dirty or if the plug is loose
●
Use a clean dry cloth to wipe the power plug clean of any dust, water or other
foreign matter and ensure it is dry before plugging in to operate the system
The system has an internal pressure safety switch (electrical shutoff) set for a
maximum of ~2 psi. If the internal pressure builds to over 2 psi the green light and the
gas production will shut off.
When the pressure is below 2 psi, the green light will turn on and the gas production
will re-start. For safety, the pressure is kept very low, and electrical shut off is used
so gas production stops. There is a mechanical gas pressure relief as a final
precaution.
2.2
Set Up
●
Position on a stable flat surface
●
For indoor use only in a well ventilated room or area
●
Do not use outdoors or in situations where the user or system could become
wet
●
Avoid direct sunlight and moisture
●
Do not install near heating equipment, electrical heating products or in other
high temperature places
●
Do not install near combustible gases or near any flammable substances
2.3
Operating the System
●
Use personal protective equipment (PPE) when preparing the electrolyte
solution
●
Prepare electrolyte (sodium hydroxide/lye) as directed and always keep off the
skin and out of the eyes
●
Only use 0 TDS water in the system
●
Replace the water in the humidifiers and system as directed
●
Clean Tubing, cannula and humidifiers as directed
●
Follow the system operation checklist prior to use
