USER MANUAL FOR THE OSMIO INFINITY HYDROXY GAS/WATER PRODUCTION ELECTROLYSIS SYSTEM
27
Never breathe gas that has not gone through BOTH Humidifiers which
have been filled to the respective fill lines. Always replace the water in
the Humidifiers with 0 TDS/Distilled water.
4.2 Topical application
1.
Turn on the system
2.
Discharge any static charge by touching the system case
3.
Check the liquid level is not low
4.
Top up the system with liquid from Humidifier 1 through the check valve using
the syringe provided if required
5.
To top up the water level first hold the lid of Humidifier-1 and unscrew the tank
6.
Allow the lid of Humidifier - 1 tank to rest on the bracket at the side of the
system (or loosely on top of the Humidifier)
7.
Use the syringe to draw up 50 ml of water
8.
Syringe the water into the system through the check valve
9.
Check the water level in the sight tube and continue to fill to a level between low
and full, taking care not to overfill (it takes a few seconds for the level to change
in the sight tube)
10.
Set DUTY to 100%
11.
Insert the long clear tube into the Spot Applicator funnel
12.
Insert the other end of the Spot Applicator tube into the gas output fitting of
Humidifier - 2 (push the tube on)
13.
Place the Spot Applicator funnel over the chosen area of your body
14.
See instructions in sections 3.8 and 3.9 for timer operation
4.3
Drinking Water
If the water in Humidifier - 2 is being used for drinking, then the water in this
humidifier must be changed every hour. The TDS of the water in Humidifier 2 must be
measured before consumption. This water can only be consumed if the TDS is
≤
1.
