SECTION 3 - MACHINE CONTROLS AND INDICATORS
31215066
3-7
5.
Jib Lift
Provides raising and lowering of
the jib.
NOTE:
Auxiliary power only works if there is no engine oil pressure, and
is disabled if engine is running.
Functions will operate at a slower than normal rate because of
the reduced hydraulic flow.
WHEN USING AUXILIARY POWER, DO NOT OPERATE MORE THAN ONE FUNCTION AT A
TIME. SIMULTANEOUS OPERATION CAN OVERLOAD THE AUXILIARY PUMP.
6.
Engine Start/ Auxiliary Power Switch
To start the engine, the switch must be held
Up until the engine starts.
To use auxiliary power, the switch must be
held Down for duration of auxiliary pump use.
WHEN THE MACHINE IS SHUT DOWN THE POWER/EMERGENCY STOP SWITCH MUST BE
POSITIONED TO THE OFF POSITION TO PREVENT DRAINING THE BATTERIES.
7.
Power/Emergency Stop Switch
A two-position red mushroom shaped switch
supplies power to Platform/Ground Select
switch when pulled out (on). When pushed in
(off), power is shut off to the Platform/Ground Select switch.
8.
Hourmeter
Registers the amount of time the machine
has been in use, with engine running. In the
event of a fault, the hourmeter also displays
the three digit fault code. Refer to the Service
Manual for a listing of fault codes. Additionally, there is a
small, red indicator light that will blink when there is a fault
on the machine to draw operator attention to the display.
9.
Display Gauge
Registers the amount of time the machine
has been in use, with engine running. The
hourmeter registers up to 16,500 hours and
cannot be reset.
To
order
go
to
Discount-Equipment.com
