Oshkosh Corporation IMT CAS80R, Инструкция по установке, эксплуатации, техническому обслуживанию и каталог запасных частей.

Страница: 13 / 68

CAS80R SECTION 3: INSTALLATION
Manual # 99905932 (February 2016) PAGE - 7
IOWA MOLD TOOLING CO., INC.
(641) 923-3711 • www.imt.com
®
3.1 MACHINE PACKAGE
RECEIPT/INSPECTION
Upon receipt of the machine package,
inspect the exterior of the shipping crate for
signs of shipping/transit damage. Any
damage should be reported immediately to
the shipping company. Open the lid and
inspect the component parts and supports to
ensure that there has been no internal
movement of assemblies or components
which may have caused damage. To install
the IMT compressor system, refer to the
following sections:
3.2 GENERAL INSTRUCTIONS
This section provides general guidance for
locating and preparing the IMT compressor
package for operation. Each installation is
unique and can be affected by location,
ventilation, and other factors such as
electrical and hydraulic power supply
availability and location.
3.3 DETERMINING THE IMT
CAS80R UNIT MOUNTING
LOCATION
When determining the location to mount the
CAS80R unit, the following criteria must be
taken into consideration:
• Refer to Section 3.10 . The location must
allow for the machine dimensions
(
Figure 3-4
), and additional space
requirements for minimum cooling,
access and maintenance. Refer to
Figure 3-4
to determine the minimum
space requirement.
• The mounting surface must be level and
able to accommodate the four [4]
mounting bolts of the base frame.
• The mounting surface must be able to
support the unit’s weight (375 lbs.).
• The external gauges must be easily
visible to the operator.
WARNING
Install, operate, and maintain this
equipment in full compliance with all
applicable OSHA, other Federal, state,
local codes, standards, and regulations.
WARNING
Before performing maintenance or repair
operations on the compressor, ensure that
all power has been removed and locked
out to prevent accidental application.
DO NOT assume that because the
compressor is in a STOPPED condition
that power has been removed.
WARNING
DO NOT perform any modifications to this
equipment without prior factory approval.
WARNING
DO NOT use plastic pipe, or incorrectly
rated piping or hose. Incorrectly rated
connection material can fail and cause
injury or equipment damage.
WARNING
DO NOT operate the compressor in
enclosed or confined spaces where
ventilation is restricted or closed off.
SECTION 3:
INSTALLATION