MSG-A • MSG-D OPERATOR INSTALLATION GUIDE
- 8 -
TORQUE LIMITER ADJUSTMENT
VENT PLUG INSTALLATION
Gear reducers used in OSCO gate operators will have solid plugs installed prior to shipment in order to keep the oil inside from
spilling out during shipping. A vent plug has been provided to replace this plug during installation. This plug will look similar to the
ones shown below. Some models may have a vent plug with a breather pin. This pin should be removed after installing the
operator.
OR
Before adjusting the torque limiter, make sure the gate is in good
working condition. One person should be able to move the gate by
hand. Be certain the gate moves freely and without binding through-
out its travel. Torque limiters are set light at the factory. They must
be adjusted during installation, preferably after limit cams have been
manually set (see page
9
). Adjust the torque limiter tight enough to
keep it from slipping during normal operation.
To adjust the torque limiter in Models MSG-A and MSG-D:
1. Loosen the setscrew in the adjustment nut.
2.
To increase the output
, turn the adjustment nut clockwise one
flat, or 1/6 turn, at a time until desired output is obtained.
To reduce the output
, turn the adjustment nut counterclockwise
one flat, or 1/6 turn, at a time until desired is obtained.
3. Tighten the setscrew when finished.
MODELS MSG-A and MSG-D
SETSCREW
ADJUSTMENT NUT
Содержание MSG-A
