16
3.3.4.1 Top / rear vent configuration
Figure 8
Steps required to change the vent configuration on your Westbay 38
1)
Remove the trivet from the top of unit.
2)
Remove stove top by removing 2 screws from the rear and one screw from each side (behind cabinet sides)
3)
Remove Heat Shield by removing 6 screws.
4)
Remove 6 screws and lift off Stove Back and Cabinet Side assembly
5)
Remove 20 screws and take off Air Intake Cover Plate. Be careful not to damage the adjoining gasket.
6)
Remove 14 screws and take off Exhaust Cover Plate. Be careful not to damage the adjoining gasket.
7)
If the unit has been previously fired, all gaskets must be replaced. Old gaskets must be removed and all surfaces
must be cleaned.
8)
Replace the Exhaust Cover Plate and the Air Intake Cover Plate with the vents pointing in the desired direction.
9)
Re-assemble all components in the reverse order in which they were removed.
10)
If you are converting from a top vent to a rear vent, remove and discard the Rear Vent Cover Plate.
