Osburn Designer DV36, Инструкция по установке и эксплуатации

Страница: 31 / 46

/25
5. Accessories
5.1 Porcelainized Combustion Chamber Panels
For installations where the Porcelainized panels are to be fitted into the combustion chamber, the following
installation and cleaning instructions are recommended.
5.1.1 Installation
1. Follow the service instructions in Section 4.4 that describe the step by step procedure to remove the
burner and logset from the combustion chamber. This must be done in advance of the panel installation.
Set the burner and log set aside and out of any traffic areas to avoid damage to the log set.
2. Position the bottom tabs of the left and right side panels into the slots on the bottom of the combustion
chamber, and rotate each into the upright position. Push the panels towards the rear of the unit, making
sure to capture the inside lip of the front of each panel with the two screw heads located on each of the
combustion chamber sides (see Figure 5.1). There are two slots in each panel that should fit snuggly
underneath the screw heads. These screws may need to be adjusted in order that the panels are properly
secured.
Figure 5.1 Installation of Left and Right Porcelain Panels