Osaki OS 4000CS, Инструкция по эксплуатации

Страница: 20 / 24

This page summarizes the most common problems you could encounter with the
product. If you are unable to solve the problem with the information below,
contact service center immediately.
If the problem encountered is not listed, please try the following suggestions:
1. Turn off the product and unplug it.
2. Wait for 60 minutes.
3. Plug the product back to the recommended outlet and restart.
4. If the problem persists, contact the authorized service center.
The product
does not work
The product
stopped
working
The product
stopped
working
The product
does not work
The product is
abnormally
warm
Noise can be
heard from the
The product is not plugged
in properly.
Ensure the voltage on the
product corresponds to the
local mains voltage and
then plug in again.Make
sure the outlet is properly
working.
If you want another session,
press the Power button
again.
Unplug the product and let it
cool down for 60 minutes
before you use it again.
Reduce the excessive load
and start again.
Unplug the product an let it
cool down before using it
again.
This is normal and does not
mean that the product is
faulty.
The product has just
finished its auto timer
session and has
automatically switched to
standby mode.
You may have used the
product continuously for 45
minutes where the over heat
protection has been
activated.
An excessive load has been
applied on the product.
The product is likely to be
overused.
Noise is made by the
mechanical parts of the
Problem Possible Cause Suggestion
Troubleshooting
18