Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
Hard Wiring Installation
Hard Wiring Connection (Cont'd)
1. Remove the cover plate from the right side bottom of
the appliance by removing the three screws
2. Remove the wire connectors from the power cord. The
power cord may be discarded
3. Take the new cover plate, supplied in the hardware
bag. Punch out the 7/8" (22mm) hole and install a box
connector through, into the junction box. Snap the box
connector clamp onto the supply wires
4. Using the wire connectors, connect the ground green
wires (G), the common white wires (N) together, then
the hot black wires (L) and then refer to Fig. 3
5. Reinstall the cover plate using the three screws, as
shown in Fig. 1 from the previous page
INSTALLATION
& ASSEMBLY
Fireplaces
MODEL
LEDFP-
5
0
| LEDFP-60 | LEDFP-72
Fig. 3
Fig. 4
Log set / Crystal / Pebble Ember
Installation
Installation depends on the embers you bought or selected.
1. Glass front must be removed and the appliance must
be mounted in its final location before the log set /
crystal / pebble embers are installed
2. If your fireplace come with log set, remove the log set
from the package, put it to the fireplace designed place
(also see Fig. 5)
3. If your fireplace come with CLEAN CRYSTAL or PEBBLE
MEDIA: Crystal or pebbles media may have a fine oil
residue that needs to be cleaned prior to installation.
Clean them with mild dish soap, drain, rinse thoroughly
and dry before placing into the tray
4. Place the plastic tray (I) to the fireplace designed place.
Then carefully place crystal or pebbles embers into the
bottom tray on the front of the appliance as illustrated.
Apply an even layer from side to side (see Fig. 6 and 7)
Ø 7/8"
(22mm)
Fig. 5
Fig. 6
Fig. 7
Fig. 8
OPERATION
Power
Plug the power cord into a 110-120V 15A grounded outlet (also see
WARNING and Application Notice on page 1 of this manual). Make
sure the outlet is in good condition and that the plug is not loose.
NEVER exceed the maximum amperage for the circuit. DO NOT plug
other appliances into the same circuit.
Methods of Operation
This electric fireplace can be operated by the CONTROL PANEL,
located on the UP right side glass panel slot of the fireplace, or by the
battery-powered REMOTE CONTROL. The operation and functions of
the two methods are the same.
Before operating, please review the WARNING and Application
Notice on page 1 of this manual and heed all warnings.
